This is a receiver/descrambler.   It has a stand-alone dish positioner.  Also, these receivers do not have menus or on screen displays. They work by pressing codes on the remote or codes that are displayed on the receiver. 

*Watch the receiver during the programming process for any execution code that may come up.

LEGEND
Blue = Buttons on Remote or Receiver

How to Program a Satellite

1. First move to the satellite with the separate dish positioner. If the polarity needs to be adjusted, it can be done with this receiver. Follow the appropriate directions from the extra function codes.

2. Press store after any changes that need to be saved.

EXECUTION CODES

Bold print is the most common codes

E-0             CHANGES STORED

E-1             SATELLITE STORED

E4             POLARITY STORED

E-5      VIDEO NON-INVERTED

E-6      VIDEO INVERTED

E-7             BASEBAND DE-EMPHASIZED IS ON

E-8             BASEBAND DE-EMPHASIZED IS OFF

E-12             NOTHING TO STORE

E-13             INVALID PROGRAM

E-20             [STORE] BUTTON DISABLED

E-99             INVALID PASSWORD                                                             

EXTRA FUNCTIONS

**Only the most common functions are listed, refer to manual for the rest.

            Function                                               XF                    Command Code           

C-BAND SINGLE FEED                            6 3 (pswd) 00 enter

C-BAND DUAL FEED                                                   01 enter

AUTO POLARITY ENABLED                                          08 enter

AUTO POLARITY DISABLED                                         09 enter

TUNING LOCK OFF                                                                 10 enter

TUNING LOCK ON                                                                  11 enter

STORE LOCK OFF                                                                 12 enter

STORE LOCK ON                                                                  13 enter

RESET CH. CHANGES                                                      17 enter

RESET SAT. CHANGES                                                      18 enter

SET PASSWORD                                                               19* (refer to manual)

ERASE ALL MEMORY                                                       93 store

To operate the Extra Functions procedures:

1. Press 6 3,

-If there is no password set, then the receiver will display F__ on the receiver. This means it is waiting for the command code for the function to be entered.

-If there is a password set, then the receiver will display PS__ on the receiver. This means that it is waiting for a password to be entered (password = 2 4 0 6). After entering the password it will then display F__, which then it is waiting for the command code for the function to be entered.

2. To enter the desired function, press the number code that corresponds to whatever function you are doing. (EX: To reset sat. changes, you would press 17). Be sure to watch the receiver it may display an execution code.