Wineguard Pinacle LEGEND
1. Start on a
satellite with the same polarity as the one you are programming. 2. Press select
twice. You will see the
“Option Menu Pg. 2” on your screen. 3. Press 3
for the Installation Menu. 4. Then press 5
for Copy Sat. The sat name
will be highlighted. Use up/down
arrows to scroll through the names if it is different from the satellite
you are on. 5. To the right of
the sat name will be a degree number. Press
right arrow to
highlight the number. Then use up/down
ARROW to change the degree number to the location of the satellite you
want to program. NOTE:
The receiver will only give the degree numbers in .5
increments. If the new satellite
position is 105.3 then go to 105.5. 6. Press select
to add new satellite to satellite menu.
“New sat added” will flash on the screen and then the Installation
Menu will come back. 7. Press 1
for Set Target Positions, then press 8 for
Calculate New Sat Positions. Press select
to activate. The new satellite will
appear in the Satellite Menu as NEW SAT.
Press view. 8. Now the new
satellite must be given a name. Press
sat twice.
You will see “Satellite Menu Pg. 2”.
The first line is “label” and should be highlighted.
If it is not use up/down
arrows to highlight label. 9. Then press right
arrow and you will see “?? New Sat” with a pointer under the first
question mark.
10. Use up/down
arrows to change the character and right
arrow to move positions. The
label consists of a two-character abbreviation and ten characters for the
satellite name. 11. After completing the label press select to save. |
|
|
We have designed this site with both our current and prospective customers in mind. If you have any bugs, broken links to report, comments, questions or suggestions about Orbit or this web site, please feel free to send a message to webmaster.