The Drake 924 features up to 9 channel
priority view memory, up to 21 programmable satellites, the ability to
lock out up to 24 channels, an on-screen display and an IR remote. This
receiver does not have menus or on-screen displays. All functions are
operated from the remote or receiver.
LEGEND
Blue = Buttons on Remote or Receiver
PROGRAM A SATELLITE
1. Go to a satellite that is next to or near to the satellite to be
programmed.
2. Select a channel that is active on the satellite that is to be
programmed and on the satellite that you are starting from.
3. On the front of the receiver: Press auto until
the auto light goes off.
4. Follow the proper procedure:
-If you are starting from a satellite with the same format,
then tap EAST or WEST
until a different picture or black screen appears.
-If you are starting from a satellite with the opposite
format, then tap east or west
until the picture is gone, then press format
one time. A picture should appear, if not continue moving east or
west until a picture or black screen appears.
5. Verify that the picture is correct. If it is, then go to step 6.
Otherwise, continue moving east or west until the correct satellite is
found.
6. Press ALPHA on the receiver until the
desired letter for the satellite to be programmed appears. Go through the
alphabet to the letter again, next press NUM on
the receiver until the desired number for the satellite to be programmed
appears and then go around to the number again.
7. After getting the correct name, hold MEMORY down
until the name blinks then stop.
8. Press AUTO and turn the auto light on.
HOW TO TURN ON/OFF A
PARENTAL LOCK
1. Go to the channel to be locked out or unlocked.
2. Press Parental-set to lock out or Parental-reset
to unlock the channel.
3. The locked out channel can be viewed if the remote is used to select
the channel.
4. The locked out channel cannot be viewed if the receiver is used to
change channels, also the satellite cannot be changed.
HOW TO DELETE A SATELLITE
1. On the front of the receiver: Press auto until
the auto light goes off.
2. Press ALPHA on the receiver until the
desired letter for the satellite to be erased appears. Then press NUM
on the receiver until the desired number for the satellite to be
erased.
3. After getting the correct name, hold CANCEL down
until the name disappears.
4. Press AUTO and turn the light back on.
HOW TO CHANGE SATELLITES
1. Press SATELLITE PRESET left or right to
scroll through the satellite names.
2. Stop on the correct satellite. The dish will then move to selected
satellite.
|